Customize your 2005 to 2011 2nd Gen Toyota Tacoma with a 3D printed ScanGauge 3 mount designed to replace the factory overhead sunglass holder. This mount provides a clean and convenient location for your ScanGauge 3 touch screen while keeping the display easily visible and accessible.

PLEASE NOTE

This listing is for the 3D printed ScanGauge 3 mount ONLY. The ScanGauge 3 is NOT included.

IMPORTANT FOR DIGITAL TEMPERATURE DISPLAY MODELS

If your overhead console is equipped with the factory digital temperature display, this mount can ONLY be installed in the sunglass holder position closest to the rear of the vehicle.

CABLE ROUTING

A 90 degree cable adapter is included to assist with routing the ScanGauge 3 cable inside the overhead console.

Depending on your installation and cable routing, an RJ45 Ethernet extension cable may also be required. The RJ45 extension cable is NOT included.

FITMENT

Designed for:

• 2005 to 2011 Toyota Tacoma

• ScanGauge 3

The mount replaces the factory overhead sunglass holder location.

MATERIAL AND FINISH

Each mount is 3D printed in black ASA for improved heat resistance and durability inside the vehicle.

The mount comes unfinished, unsanded, and unpainted, allowing you to install it as is or customize the finish to your preference.

As with all 3D printed products, minor layer lines, surface variations, or small cosmetic imperfections may be present. We do our best to provide a clean, durable, high quality print with every order.

INCLUDED

• 1x 3D printed ScanGauge 3 mount

• 1x 90 degree cable adapter

NOT INCLUDED

• ScanGauge 3

• RJ45 Ethernet extension cable

• Wiring or other accessories