Customize your 2001 to 2007 Toyota Sequoia or 2001 to 2006 Toyota Tundra with a 3D printed ScanGauge 3 mount designed to replace the factory ashtray. This mount provides a clean OEM style appearance while allowing the ScanGauge 3 wiring to be routed neatly through the dash.

PLEASE NOTE

This listing is for the 3D printed ScanGauge 3 mount ONLY. The ScanGauge 3 is NOT included.

INSTALLATION

Installation is simple and requires removal of the factory ashtray.

• Pull the factory ashtray straight out to remove it

• Slide the longer flat section of the mount through the slots located on the sides of the ashtray opening

• Install your ScanGauge 3 into the mount and route the wiring through the dash

The mount also features two thumb openings to make removing the ScanGauge 3 easier when needed.

FITMENT

Designed for:

• 2001 to 2007 Toyota Sequoia

• 2001 to 2006 Toyota Tundra

MATERIAL AND FINISH

Each mount is 3D printed in black ASA for improved heat resistance and durability inside the vehicle.

The mount comes unfinished, unsanded, and unpainted, allowing you to install it as is or customize the finish to your preference.

As with all 3D printed products, minor layer lines, surface variations, or small cosmetic imperfections may be present. We do our best to provide a clean, durable, high quality print with every order.

INCLUDED

• 1x 3D printed ScanGauge 3 mount

NOT INCLUDED

• ScanGauge 3

• Wiring or other accessories