Customize your 2012 to 2015 2nd Gen Toyota Tacoma with a 3D printed ScanGauge 3 mount designed to replace the factory overhead sunglass holder. This mount provides a clean and convenient location for your ScanGauge 3 touch screen while keeping the display easily visible and accessible.

PLEASE NOTE

This listing is for the 3D printed ScanGauge 3 mount ONLY. The ScanGauge 3 is NOT included.

IMPORTANT SUNGLASS HOLDER COMPATIBILITY

Toyota used two slightly different OEM overhead sunglass holder designs on the 2012 to 2015 Tacoma. These designs are NOT interchangeable, so please make sure to select the correct position before ordering.

FRONT

Sunglass holder closest to the windshield

REAR

Sunglass holder closest to the rear of the vehicle

IMPORTANT FOR DIGITAL TEMPERATURE DISPLAY MODELS

If your overhead console is equipped with the factory digital temperature display, this mount can ONLY be installed in the rear sunglass holder position closest to the rear of the vehicle.

CABLE ROUTING

A 90 degree cable adapter is included to assist with routing the ScanGauge 3 cable inside the overhead console.

Depending on your installation and cable routing, an RJ45 Ethernet extension cable may also be required. The RJ45 extension cable is NOT included.

FITMENT

Designed for:

• 2012 to 2015 Toyota Tacoma

• ScanGauge 3

MATERIAL AND FINISH

Each mount is 3D printed in black ASA for improved heat resistance and durability inside the vehicle.

The mount comes unfinished, unsanded, and unpainted, allowing you to install it as is or customize the finish to your preference.

As with all 3D printed products, minor layer lines, surface variations, or small cosmetic imperfections may be present. We do our best to provide a clean, durable, high quality print with every order.

INCLUDED

• 1x 3D printed ScanGauge 3 mount

• 1x 90 degree cable adapter

NOT INCLUDED

• ScanGauge 3

• RJ45 Ethernet extension cable

• Wiring or other accessories